throttle linkage for new 500 edelbrock carb

[chuck43]

I'm building a 1991 s-10 with a 1998 vortex v-6 and changed the manafold to a edelbrock 2114 manf & 500 cfm edelbrock carb Ive seen some pictures of this setup in the forum my question is do those guys have any pictures of the set up that they are using it sure would help me out alot

[Tink]

Would the set-up on a V8 help? It is running an edelbrock carb and 700R4 tranny... Had to modify the edelbrock's linkage to get it to work...

[chuck43]

it sure would, it sure couldn't hurt and thank you

[Tink]

I'll try to get a picture of it tonight after work...

[Tink]

Here ya go...

The bracket is from Summit (it is adjustable) and the extra linkage piece came off the quadrajet that was on the truck before. I'm pretty sure Holley has a similar bracket to attach to the linkage that gives you the right kick-down adjustment for the 700R4. Hope this helps!

[chuck43]

Mr Tink thank you so much this will help take all the guess work out of it