2" block questions

[White-V-6-S-Ten]

Do they need to be angled? I have a set of 3" angled blocks on there now and have been thinkin about puttin 2" ones on there so my back end lifts up a little so it has kinda the hot rodder look.
What do you guys think?

[12sws27]

I would say so. I have 2" blocks on mine right now. I plan on getting and pinion alignment kit from JTR after I buy/install Zq8 leafs. Anyways, I notice a vibration when I step on the gas hard. That's usually a sign that there is some binding from the pinion angle being wrong. So I would suggest getting some on the pinion correction shims from JTR or something.

[White-V-6-S-Ten]

Just what i was thinkin. A buddie has some flat 2" blocks and i was thinkin they wouldnt work cause they werent angled.

[12sws27]

If you drive normally and/or don't carry loads it would be fine. It's when the ass end swats down, when it binds.

[87wildside]

Angled yes. Rake yes.