importmaster1300
10-29-04, 03:26 PM
I attached everything that SHOULD be installed w/ an amp.Its at the bottom of this artical.
Amps come in 1 channel mono, 2 channel, 4 channel, 4channel 1 mono, etc.
The "channels" are the outputs from the amp to your speakers.
You will need the amp install kit. Take the ground wire and connect it to the amp -neg terminal. Take the power wire and hook it to the +12 side of your battery.DONT INSTALL THE FUSE YET!!!
run wire to rem. side of the amp it can be 12 to 18ga wire to the ign. side of the stereo (or power antenna).
Now you need to install rca cables from the stereo to the amp.
Next install your speakers put those wires in the pos. and the neg. OUTPUT side of the amp. :mad: >>>>>>NOT THE BATTERY + and -!!!!!!!!!!!!!!!!!!
install the fuse and you are done w/ the install!
Amps come in 1 channel mono, 2 channel, 4 channel, 4channel 1 mono, etc.
The "channels" are the outputs from the amp to your speakers.
You will need the amp install kit. Take the ground wire and connect it to the amp -neg terminal. Take the power wire and hook it to the +12 side of your battery.DONT INSTALL THE FUSE YET!!!
run wire to rem. side of the amp it can be 12 to 18ga wire to the ign. side of the stereo (or power antenna).
Now you need to install rca cables from the stereo to the amp.
Next install your speakers put those wires in the pos. and the neg. OUTPUT side of the amp. :mad: >>>>>>NOT THE BATTERY + and -!!!!!!!!!!!!!!!!!!
install the fuse and you are done w/ the install!