Replacing the front breaks

[S-DimeIn]

Ok first I do know how to do the pads but i need to do the roter/hub assembley. i have taken it off but when i put it back on it did not sit right i had to get it fixed it was loose. so my question it who has done it and how tight do i tighen the bolt down on the spindal. i see the hole for the cauter pic so it should not be that tight. and what are some tips on the seal part.

[T Man]

The castle nut should be about 11ft/lb's or finger tight

[S-DimeIn]

that is when you put it back on right

[Hammer Head]

Yes, & then put a new cotter pin through it..be sure to bend the pin over so it doesn't come out.

[00S104.3]

Don't forget to repack the bearings.:)

[Hammer Head]

..if we're gonna go that far... don't forget to install the dust cap, too.. you did remeber to save that didn't you? If not you'll have to go get another one, uh oh.

[Maximus]

Always repack those bearings.