95 ses light

[jetsport]

is there any way to pull trouble codes from a 95 S-10 OBD 1.5

[Sparky2263]

Lots of parts places do it for free.

[Tink]

For OBD 1.5 (16 pin ALDL) short terminals 5 & 6...

http://www2.eboard.com/boards/9/50/68/tink/att-984326/aldl.jpg

Turn key on, but do not start engine. Find and Short terminals with a paper clip. The check engine light will begin to flash. The ECM (computer) will display a "code 12" by flashing the "service engine soon" light, indicating that the system is operating. A code 12 is simply one flash, followed by a brief pause, then two flashes in quick succession. This code will be flashed 3 times. If no other codes are stored, code 12 will flash until the diagnostic terminal ground is removed. After flashing code 12 3 times, the ECM will display any stored trouble codes. Each code will be flashed 3 times, then code 12 will be flashed again, indicating that the display of any stored trouble codes has been completed.

[jetsport]

thank you, but i have no metal pin in teminal 6. i have metal pins in terminals 2,4,5,9,13,16 this stinks.

[Sparky2263]

No AutoZone or O'Reillys nearby to scan it for you? No friends with a scanner? Those things are getting bad cheap now.

[jetsport]

most scaners will not work on OBD 1.5 (early 95) it was a cross over year.but thax for your input. i guess i have to pay the dealer.

[rlith]

most scaners will not work on OBD 1.5 (early 95) it was a cross over year.but thax for your input. i guess i have to pay the dealer.

Is your ECM under the dash on or top of the coolant recovery tank?

[jetsport]

my ecm is over the coolant recovery tank.

[Sparky2263]

Then any OBD2 scanner should pull the codes. All mine do. You may have to put "T" (1996) in for the year when scanning though. Some scanners think OBD1 when you tell it 95.

[J_Bone]

Cool, I need to find out what's wrong with mine as well. I get the ABS light on in mine.