vacuum line diagram?

[mxm]

anyone got a vacuum line diagram for a 94 s10 v6? just wondering, seeing as my lines are dry rotted to hell, and i only see a handful of lines and i want to replace all that i can. just figured this would really help as i could not find a diagram in my haynes or 1mitchel.com manuals....thanx

[mxm]

ok, i found a crude vacuum diagram for S & T series s-10's. i am just wondering if this is what i have. i know i have a 4.3 v6 vin w engine, but this s or t series...what is that?

btw, another reason i am doing this is because i believe one of my lines might be clogged...leading to hard starting. i have to crank the engine 2-5 times before i get it going...unless its warm out, then it'll start immediately....too hot or cold, it takes a few times. i was also told it may be the engine coolant sensor...i believe this is right on the lower intake plenum...any insight?

i also plan to change the fuel regulator out because i read all the stories on here about it.....any insight would be helpful....thank you all

[mxm]

i forgot to post this, but this is the picture of the diagram...taken off of 1Mitchel.com errrrr eautorepair......whatever

[87wildside]

The "T" trucks are the 4wd s seires.

[dalefanone]

I'm looking for a vacuum diagram for the tranfer case and have found nothing in any of the manuals either...grrrrrrrrrrrrr what happened to repair manuals??

[dalefanone]

ps.I'm running a 94 Jimmy s-15 with a 4.3 vortec

[Blazer69]

i wouldn't mind a 4x4 vacuum diagram.....