nolongergreen
07-02-07, 10:46 PM
I am selling my "super sleeper" s-10 for something a little easier for the wife to drive.
I ride and race motorcross bikes and I am going to buy an enclosed trailer and use her Tahoe for pulling it which means that the s-10 must go so I can get her something to run around in while im gone.
I have invested so much money into this truck (around 11,000) and hate to take a hit but its time to be more responsible. lol
There are way too many mods to list but I will try to list most of them.
1995 s-10 355 sbc
2000 front end and wheels
355 short block assembly with less than 500 miles, dead serious and have reciepts to prove purchase time
iron eagle 205/160 valve platiunum angle plug heads
700r4 trans just built and picked up friday 6-29-07
b&m ratchet shifter
3.73 gears with posi traction
3000 b&m holeshot stall convertor
big tach with shiftlight
nos pressure guage
oil pressure guage
temp guage
leather bucket seats out of a blazer
nos sniper system adjustable up to 150 shot (not sprayed yet on this motor)
air gap intake
holley 750 double pumper carb w/ electric choke
k&n filter
msd ignition
msd digital rpm window swith for the nos
headers
"X" pipe with dual flowmasters
drop kit 2" in the rear
flexalitle electric fan with twin core northern alluminum radiator
There is about double this actually in it but thats all i can remember right now.
Make an offer, trade plus 3000 cash or so?
nolongergreen@charter.net
I ride and race motorcross bikes and I am going to buy an enclosed trailer and use her Tahoe for pulling it which means that the s-10 must go so I can get her something to run around in while im gone.
I have invested so much money into this truck (around 11,000) and hate to take a hit but its time to be more responsible. lol
There are way too many mods to list but I will try to list most of them.
1995 s-10 355 sbc
2000 front end and wheels
355 short block assembly with less than 500 miles, dead serious and have reciepts to prove purchase time
iron eagle 205/160 valve platiunum angle plug heads
700r4 trans just built and picked up friday 6-29-07
b&m ratchet shifter
3.73 gears with posi traction
3000 b&m holeshot stall convertor
big tach with shiftlight
nos pressure guage
oil pressure guage
temp guage
leather bucket seats out of a blazer
nos sniper system adjustable up to 150 shot (not sprayed yet on this motor)
air gap intake
holley 750 double pumper carb w/ electric choke
k&n filter
msd ignition
msd digital rpm window swith for the nos
headers
"X" pipe with dual flowmasters
drop kit 2" in the rear
flexalitle electric fan with twin core northern alluminum radiator
There is about double this actually in it but thats all i can remember right now.
Make an offer, trade plus 3000 cash or so?
nolongergreen@charter.net