DMP
10-25-07, 02:19 AM
http://www.s10planet.com/forum/showthread.php?t=4253, "doing some stop-and-go driving around town at speeds up to about 30 mph followed by five to seven minutes of 55 mph plus highway speed driving will usually set most or all of the monitors (the converter and EVAP system readiness monitors are the hardest ones to set). So if you're checking the OBD II system and find a particular monitor is not ready, it may be necessary to test drive the vehicle to set all the monitors."
Now I drove my truck about 150 miles and reached speeds 65+ mph. I plugged in my OBD2 scanner and had no luck with the readiness monitors. Any tricks to set the monitors off or do I need to keep driving?
Now I drove my truck about 150 miles and reached speeds 65+ mph. I plugged in my OBD2 scanner and had no luck with the readiness monitors. Any tricks to set the monitors off or do I need to keep driving?